Cable de red LOGON TCR55SS150W Cat5e F/UTP (FTP) 15 m blanco RJ-45–RJ-45

LOGON TCR55SS150W Cat5e F/UTP (FTP) 15 m is a shielded Ethernet patch cable with RJ-45 connectors on both ends designed for wired LAN installations. The cable meets Cat5e performance parameters and is intended for data and voice transmission in home, office and rack environments. Its foil-shielded F/UTP construction and white outer jacket help reduce electromagnetic interference in crowded cable runs while keeping a discreet appearance.

Advantages

The foil shield around the twisted pairs provides improved protection against external noise compared with unshielded cables, which helps maintain signal integrity in environments with nearby power lines, network equipment or dense cabling. Shielded RJ-45 connectors and boots with kink protection and strain relief increase connector reliability and reduce mechanical stress at termination points. The 15 m length allows flexible placement of devices without relying on intermediate patch panels or additional extenders.

Suitable for

• Wired connections between switches, routers and workstations in offices
• Patch connections in server racks and patch panels
• Home network links for IPTV, VoIP and broadband modems
• Environments with moderate electromagnetic interference requiring shielded cabling

Key specifications

• Cable category: Cat5e (F/UTP, FTP)
• Length: 15 m
• Conductor: 4 pairs, 26 AWG stranded (26/7)
• Impedance: 100 Ohm
• Connectors: RJ-45 male – RJ-45 male, shielded
• Boot: anti-kink boot with strain relief
• Certification: Category 5e performance (3P Cat 5e certified)
• Color: White
• Installation: Plug-and-play, pre-terminated patch cable

How to use

Connect one RJ-45 plug to the network device (switch, router, modem or network card) and the other plug to the destination device or patch panel. Ensure that shielded connectors are properly mated with equipment that has shielded RJ-45 ports or is grounded to benefit from the cable’s foil shield. Avoid sharp bends and excessive pulling forces when routing the cable; use the integrated boot and strain relief to protect the termination during handling and installation.

Recommendations

For best performance, route the cable away from high-voltage power lines and large electric motors. When connecting to shielded equipment, ensure chassis grounding to allow the foil shield to dissipate interference. Do not exceed recommended bend radius and avoid crush forces to preserve signal integrity over the 15 m length.