Cable de red LOGON UTP Cat.5e 1,5 m, RJ-45 a RJ-45, blanco

LOGON UTP Cat.5e networking cable 1.5 m, RJ-45 to RJ-45, White is a 1.5 metre unshielded twisted pair patch cable designed for short-range Ethernet connections in home and office networks. The cable follows the Cat5e standard for 100 MHz performance, features four twisted pairs of 26 AWG conductors and comes with RJ-45 plugs on both ends with integrated boots that provide kink protection and strain relief. The white jacket provides a neutral appearance suitable for visible installations and standard LAN patching tasks.

Advantages

This Cat5e UTP cable offers reliable 100 Ohm transmission characteristics for typical Ethernet and Fast Ethernet connections. The 26/7 stranded conductors balance flexibility and signal integrity for frequent plugging and routing in patch panels, desks or network cabinets. Molded boots with strain relief help reduce connector stress and the 1.5 m length is convenient for connecting nearby devices such as routers, switches, modems and wall outlets without excess cable.

Suitable for

• Connecting a PC, laptop or game console to a router or switch
• Patching between switch ports in a small office or home network
• Linking a modem to a router or gateway
• Short runs within server racks, wall outlets or patch panels

Key specifications

• Category: Cat5e UTP (unshielded twisted pair)
• Length: 1.5 m
• Conductor: 4 pairs, 26 AWG (stranded, 7 strands)
• Characteristic impedance: 100 Ohm
• Connectors: RJ-45 male to RJ-45 male with molded boots and strain relief
• Color: White
• Cable construction: 4 x 2 twisted pairs

How to use

Insert one RJ-45 connector into the Ethernet port of the network device and the other end into the router, switch or wall outlet. Ensure connectors are fully seated until the latch clicks. Route the cable to avoid sharp bends and avoid running it parallel to mains power cables for long distances. The molded boots help prevent kinking at the connector; when unplugging, press the connector latch and pull on the boot rather than the cable to reduce strain.

Recommendations

Use this 1.5 m LOGON Cat5e UTP cable for short, in-room connections where Cat5e performance is sufficient. For runs longer than typical patch lengths or environments with high electromagnetic interference, consider using shielded cable or a higher-category cable (Cat6/6a) as appropriate.