Cable de red LOGON UTP Cat.5e 20 m, RJ-45—marfil

LOGON UTP Cat.5e network cable, 20 m in length and finished in ivory, is designed for reliable Ethernet connections in home and office environments. This unshielded Cat5e patch cable carries data and voice signals over twisted pairs with a nominal impedance of 100 Ohm and is terminated with RJ-45 male connectors on both ends. The integrated boot with kink protection and strain relief helps prevent connector damage during installation and everyday use, while the 26/7 AWG conductor construction supports typical Cat5e performance for short to medium cable runs.

Advantages

The cable offers standard Cat5e transmission characteristics suitable for 10/100/1000 Mbps network segments where Cat5e is acceptable. Its unshielded design simplifies installation in typical residential and office spaces, and the pre-terminated RJ-45 plugs enable plug-and-play connectivity to switches, routers, modems and patch panels. The boot design with strain relief reduces stress on the connector and helps maintain reliable contact over time.

Suitable for

• Connecting desktop PCs, printers and networked peripherals to a switch or router
• Patch panel to switch or wall outlet patching in small office/home office installations
• Linking routers, modems and network devices over short to medium distances up to 20 m
• Temporary or permanent cabling where unshielded Cat5e performance is sufficient

Key specifications

• Length: 20 m
• Category: Cat5e (UTP)
• Connector type: RJ-45 male to RJ-45 male
• Conductor: 4 pairs, 26 AWG, stranded (26/7)
• Characteristic impedance: 100 Ohm
• Color: Ivory
• Boot with kink protection and strain relief
• Spot length marking on boot

How to use

Route the cable between the two networking devices and insert the RJ-45 plugs into the corresponding Ethernet ports until they click. Avoid sharp bends and do not exceed the minimum bend radius recommended for twisted-pair cables to maintain signal quality. Use cable clips or ties to secure the run and prevent mechanical strain; ensure the booted connector remains accessible for removal or reconfiguration.

Recommendations

For optimal performance, keep the cable away from strong sources of electromagnetic interference such as large electrical motors, fluorescent ballasts or power mains. Use this Cat5e cable for typical 10/100/1000 Mbps Ethernet links within its 20 m length; for longer runs or environments with high interference consider higher category cable or shielded variants.