Cable de red LOGON UTP Cat.5e rojo 30 m — RJ-45 a RJ-45, Cat5e

LOGON UTP Cat.5e Red 30 m is a factory-terminated network patch cable designed for Ethernet installations that require Cat5e performance. The cable is an unshielded twisted-pair (UTP) construction with four twisted pairs and 26 AWG conductors, terminated with RJ-45 plugs on both ends and fitted with boots providing kink protection and strain relief. Its 30-meter length and red jacket make it suitable for visible runs, patch panels and interconnecting switches, routers or other network devices in home and office environments where stable 100/1000 Mbps links are needed.

Advantages

The cable uses 4 x 2 AWG 26/7 twisted pairs with a nominal 100 Ω impedance, ensuring consistent signal transmission for Cat5e-class networks. Factory-terminated RJ-45 plugs and molded boots with strain relief reduce installation time and protect the connector from mechanical stress. The single-colour red jacket simplifies cable identification in multi-run environments and the 30 m length reduces the need for additional couplers or extension points.

Suitable for

• LAN patching between switches, routers and patch panels
• Permanent or temporary Ethernet runs in offices and homes
• Connecting network devices requiring 100/1000 Mbps links
• Visible cable runs where colour-coding aids identification

Key specifications

• Category: Cat5e
• Length: 30 m
• Conductor: 26 AWG, 7-strand per conductor
• Pairs: 4 twisted pairs, UTP (unshielded)
• Characteristic impedance: 100 Ω
• Connectors: RJ-45 male to RJ-45 male
• Jacket colour: Red
• Connector protection: Molded boot with kink protection and strain relief

How to use

Route the LOGON Cat5e cable along the intended path, avoiding sharp bends and sources of strong electromagnetic interference. Insert the RJ-45 plugs into the corresponding Ethernet ports of switches, routers or network devices until the latch clicks. Use the colored jacket to maintain clear cable identification at both ends. For permanent installations, secure the cable with appropriate clips or ties without compressing the jacket or bending it beyond its minimum bend radius.

Recommendations

For reliable performance, avoid running the cable parallel to high-voltage power lines and keep a separation distance from large electrical equipment. Test each link with appropriate network testers after installation to verify continuity and signal quality. Use the red colour coding to mark specific circuits or device groups in multi-cable setups and replace cables showing visible damage to the jacket or connectors.