Cable de red LOGON UTP Cat5e 3 m, RJ-45–RJ-45, naranja

LOGON UTP Cat5e network cable, 3 m long, provides a reliable unshielded twisted-pair link with RJ-45 connectors on both ends for standard Ethernet connections. The orange jacket makes the cable easy to identify within cable bundles or patch panels. Designed to meet Cat5e performance parameters, this patch cable supports common home and office networking tasks such as connecting routers, switches, modems, network interface cards and patch panels.

Advantages

The cable uses four twisted pairs with 26 AWG conductors and 100 Ohm characteristic impedance to ensure consistent signal integrity for Fast Ethernet and typical Gigabit Ethernet environments constrained by Cat5e performance. Molded boots with kink protection and strain relief reduce connector stress and extend service life, while the unshielded construction keeps the cable flexible and easy to route.

Suitable for

• Connecting computers, routers and switches in home and small office networks
• Patching ports in network racks and patch panels
• Temporary or fixed installations where a visible cable color aids identification
• Extending or replacing existing Cat5e links up to 3 metres

Key specifications

• Length: 3 m
• Cable type: UTP (unshielded twisted pair)
• Standard: Cat5e
• Conductor: 4 pairs, 26 AWG (7 strands)
• Characteristic impedance: 100 Ohm
• Connectors: RJ-45 male — both ends
• Jacket colour: Orange
• Molded boot with kink protection and strain relief; length marking on boot

How to use

Insert each RJ-45 connector into the corresponding Ethernet port on devices such as a computer, switch or router until the latch clicks. Route the cable to avoid sharp bends and secure it with appropriate cable management to prevent tension on the connectors. For patch panel installations, align the connector with the panel port and insert until seated; when removing, press the latch before pulling the connector out.

Recommendations

For best performance, avoid running the UTP cable parallel to power lines or near sources of strong electromagnetic interference. Use proper cable ties or Velcro straps to prevent crushing the cable, and replace the cable if the connector housing or conductor insulation is visibly damaged.