Cable de red LOGON UTP Cat5e amarillo 7,5 m, RJ-45 a RJ-45

LOGON UTP Cat5e Yellow 7.5 m network cable with RJ-45 connectors on both ends is an unshielded twisted pair cable designed to support Cat5e performance for Ethernet data transmission. With a 7.5 metre length and a bright yellow jacket, this patch cable is intended for linking network devices, extending LAN runs, and making patch-panel or wall-plate connections in home and office environments.

Advantages

The cable provides Cat5e-rated transmission characteristics over a 100 Ohm UTP construction, using four twisted pairs of 26 AWG (26/7) conductors to maintain signal integrity for typical Ethernet speeds supported by the Cat5e standard. Fitted RJ-45 male connectors at both ends include boots with kink protection and strain relief to reduce connector stress and improve connector longevity. The yellow jacket makes the cable easy to identify in multi-cable installations and simplifies cable management.

Suitable for

• Connecting switches, routers and network interfaces in home or small office LANs
• Patching between patch panels and wall sockets in structured cabling
• Extending Ethernet device connections where a 7.5 m length is required
• Temporary or permanent connections for printers, IP cameras and set-top boxes

Key specifications

• Length: 7.5 m
• Cable type: Unshielded Twisted Pair (UTP), Cat5e
• Conductor: 4 pairs, 26 AWG (26/7)
• Characteristic impedance: 100 Ohm
• Connectors: RJ-45 male to RJ-45 male with boots and strain relief
• Jacket colour: Yellow

How to use

Plug the RJ-45 male connectors into the corresponding Ethernet ports of your network devices, ensuring secure seating until the connector latch clicks. Route the cable to avoid sharp bends and areas of mechanical stress; use the integrated boot and strain relief to minimize wear at connector ends. For structured installations, use cable clips or cable management panels to secure the run and maintain tidy routing.

Recommendations

Use the cable for Cat5e-compatible Ethernet networks and avoid placing it near sources of strong electromagnetic interference such as high-voltage power lines or large motors. For runs longer than the specified 7.5 m or where higher performance (Cat6/Cat6a) is required, select an appropriate cable rated for the desired distance and bandwidth.