Cable de red QOLTEC UTP Cat6 10 m, 2×RJ45, negro

Ethernet patch cord QOLTEC UTP Cat6 10 m, 2×RJ45, black is a straight-through network cable designed for wired LAN connections. The cable supports Category 6 cabling standards, providing reliable signal transmission for home, office and data-cabinet networks. With two RJ45 connectors and a 10 metre length, this QOLTEC patch cord connects routers, switches, patch panels and network devices while its flexible black jacket and moulded connector boots facilitate easy routing and installation.

Advantages

The Cat6 construction reduces crosstalk and maintains consistent data transfer rates compared with lower-category cables. Molded RJ45 plugs ensure secure contacts and strain-relief at connector ends to extend service life under regular handling. The 10 m length offers extended reach without the need for additional couplers, and the flexible outer jacket simplifies routing through racks, cable trays and along walls. The neutral black colour blends with most installations and minimizes visible cable clutter.

Suitable for

Key specifications

How to use

Plug one RJ45 connector into the network device (router, switch, computer or patch panel) and the other into the corresponding port on the second device. Ensure connectors click into place and that the cable is not pinched or tightly bent near the connector boots to avoid signal degradation. For installations in racks or along walls, route the cable along cable management paths and secure with appropriate ties or clips to prevent strain on the connectors.

Recommendations

For best performance, avoid running the cable parallel to high-voltage power lines and keep bend radius larger than the connector boot. Inspect connectors periodically for damage and replace the cable if crimps or exposed conductor are visible. Use Cat6-rated patchcords for Gigabit Ethernet links and where reduced crosstalk is required.