Cable de red Renkforce RF-4145295 15m Cat6a S/FTP gris

The Renkforce RF-4145295 15m Cat6a S/FTP networking cable provides a long, shielded connection for demanding Ethernet environments. Designed for high-speed data transfer up to 10000 Mbit/s, the cable uses S/FTP shielding to reduce electromagnetic interference and maintain stable signal quality over its 15-metre length. Both ends are fitted with standard RJ-45 connectors and the cable is finished in grey for unobtrusive integration into home or office networks.

Advantages

S/FTP shielding offers enhanced protection against crosstalk and external electromagnetic interference, improving performance in congested cable environments. The Cat6a specification supports higher bandwidth and 10 Gigabit Ethernet applications over copper cabling. A 15 m length gives flexibility in device placement without reliance on intermediate switches or signal extenders. Standard RJ-45 connectors ensure compatibility with most network equipment.

Suitable for

• 10 Gigabit Ethernet connections in home and small office networks
• Connecting switches, routers, NAS devices and desktop computers
• Wiring in areas with potential electromagnetic interference (near power lines or dense cable bundles)
• Temporary or permanent installations requiring a 15 m patch cable

Key specifications

• Cable category: Cat6a
• Shielding: S/FTP (overall braid with individually shielded pairs)
• Maximum data rate: up to 10000 Mbit/s
• Length: 15 m
• Connector type: RJ-45 on both ends
• Color: Grey

How to use

Insert the RJ-45 connector into the Ethernet port of your device until it clicks and connect the other end to the switch, router or modem. For optimal performance, avoid sharp bends and tight coils — maintain gentle curves and secure the cable with cable ties or clips where needed. When routing alongside power cables, maintain separation to reduce the risk of interference. If installing in a permanent route, allow some slack to accommodate movement and reconfiguration.

Recommendations

Use the cable for direct device-to-device connections within the 15 m length to benefit from Cat6a bandwidth and S/FTP shielding. Test connections after installation and replace any cable that shows visible damage or degraded performance.