Cable de red ShiverPeaks 08-64022 CAT 6 S/FTP PIMF, 4 pares trenzados, apantallamiento S/FTP

ShiverPeaks 08-64022 CAT 6 S/FTP PIMF network cable is built for structured cabling and reliable gigabit Ethernet connections. The cable contains four twisted pairs with pair-in-metal-foil (PIMF) construction and an overall braided plus foil shield (S/FTP), reducing alien crosstalk and external electromagnetic interference. It is suitable for horizontal runs, patching, and general office or data centre wiring where Category 6 performance is required.

Advantages

The S/FTP design combines an overall shield with individually foil-wrapped pairs to provide enhanced protection against near-end crosstalk and external noise sources. This construction supports stable transmission at Category 6 frequencies, helps maintain signal integrity over typical installation lengths, and is compatible with standard RJ45 terminations and patch panels designed for CAT6. The cable’s four twisted pairs and consistent pair twist rates improve performance for gigabit Ethernet and reduce error rates in congested cable environments.

Suitable for

• Gigabit Ethernet installations in offices and data centres
• Horizontal cabling and backbone segments within structured cabling systems
• Patch panels and switch-to-workstation patching
• Environments with moderate electromagnetic interference where shielded cable is preferred

Key specifications

• Category: CAT 6 performance class suitable for gigabit networks
• Cable type: 4-pair twisted conductors with pair-in-metal-foil (PIMF)
• Shielding: Overall shield plus individually foil-wrapped pairs (S/FTP)
• Conductor arrangement: Four twisted pairs for balanced differential signalling
• Typical use: Structured cabling, patching, horizontal runs

How to use

Install the cable following standard structured cabling practices: route the cable through cable trays or conduits avoiding high-power electrical lines, maintain minimum bend radius during installation, and terminate using compatible RJ45 connectors or keystone jacks designed for shielded CAT6 cables. Ensure the cable shield is properly grounded at termination points to preserve shielding effectiveness. For patching, use compatible shielded patch panels and patch cords, and label runs for easier maintenance.

Recommendations

For optimal performance, keep run lengths within standard cabling limits for horizontal cabling and avoid sharp bends or kinks. When installing in environments with potential interference, verify that shield continuity and grounding are correctly implemented at both ends. Use certified testing equipment after installation to confirm Category 6 performance parameters such as attenuation and near-end crosstalk.