Cable de red ShiverPeaks BS75111-0.5R rojo 0,5 m

The ShiverPeaks BS75111-0.5R Red 0.5m is a short networking patch cable compliant with Cat5e performance. It has foil-shielded twisted pairs with an overall drain/foil configuration (F/UTP) to reduce electromagnetic interference and maintain signal integrity in environments with moderate external noise. Both ends are terminated with standard RJ-45 plugs for straightforward connection to switches, routers, patch panels or network ports on computers and other devices.

Advantages

This 0.5 metre cable combines Cat5e data rates with F/UTP shielding to provide balanced performance and interference protection in compact installations. The short length minimises cable clutter and latency in dense rack or desktop setups. The red jacket improves visual identification in cable runs and simplifies maintenance and fault tracing without compromising electrical performance.

Suitable for

• Short patching between network devices in racks and wall outlets
• Desktop connections from PC to switch or router
• Organised patch panels and lab test benches
• Temporary network setups and demonstrations

Key specifications

• Category: Cat5e performance for Ethernet up to 1 Gbps
• Shielding: F/UTP (foil overall with unshielded pairs)
• Connector type: RJ-45 plugs on both ends
• Length: 0.5 metres
• Colour: Red jacket for visual identification
• Cable use: Patch cable for horizontal or equipment interconnects

How to use

Plug one RJ-45 connector into the network port of your device and the other into the corresponding switch, router, or patch panel port. Ensure connectors click into place and that the cable is routed to avoid sharp bends or crushing. For best performance, keep the cable away from strong sources of electromagnetic interference and avoid excessive stretching; the F/UTP shielding helps mitigate nearby noise but does not replace proper installation practices.

Recommendations

Use the red cable to mark critical links or test connections in patch panels. For permanent horizontal runs or where higher bandwidth and future-proofing are required, consider Cat6 or higher category cables. Inspect connectors periodically for signs of wear or corrosion and replace the cable if physical damage is found.