Cable de red ShiverPeaks RJ45/RJ45 Cat6a 7,5m

The ShiverPeaks RJ45/RJ45 Cat6a networking cable, 7.5 meters in length, provides a shielded S/FTP design to support reliable high-speed data transmission. This white Cat6a patch cable uses RJ45 connectors on both ends for straightforward connection to routers, switches, network cards and other Ethernet-enabled devices. The cable is intended for structured cabling runs where improved noise immunity and consistent gigabit-plus performance are required.

Advantages

The S/FTP shielding combines an overall foil shield with individually shielded pairs to reduce electromagnetic interference and crosstalk, improving signal integrity over longer runs. Cat6a specification support enables higher frequencies and better attenuation performance compared with lower-category cables, making the cable suitable for 10 Gbps Ethernet in many environments. The fixed 7.5 m length simplifies planning for desktop to wall-port connections or inter-rack patching while the standard RJ45 connectors ensure broad device compatibility.

Suitable for

• Connecting desktop computers, printers or IP phones to wall outlets or patch panels
• Linking switches and routers within small office or home networks
• Temporary or permanent patching in server rooms and network cabinets
• High-speed data tasks such as video streaming, large file transfers and VoIP

Key specifications

• Cable category: Cat6a
• Shielding: S/FTP (overall foil + individually shielded pairs)
• Connector type: RJ45 to RJ45
• Length: 7.5 m
• Color: white
• Intended use: Ethernet networking, up to 10 Gbps depending on environment and devices

How to use

Route the cable between network devices so it is free from excessive bends and mechanical stress. Insert each RJ45 connector fully into the corresponding network port until a click confirms a secure connection. For cleaner installations, run the cable along walls or through cable management channels and avoid running it in parallel with high-voltage power lines to minimize interference. If terminating at patch panels or keystone jacks, ensure connectors and ports are compatible with Cat6a performance requirements.

Recommendations

For optimal performance, verify that connected devices and intermediate hardware (patch panels, switches) support the desired network speed. Keep cable bend radius at or above the manufacturer’s recommended minimum and avoid tight crimps. When installing in mixed-cable environments, maintain physical separation from power conductors to preserve shielding benefits.