Cable de red UTP Cat5e LOGON 10 m, RJ-45—RJ-45, verde

LOGON UTP Cat5e network cable, 10 m length, provides a reliable unshielded twisted pair connection for Ethernet networks. Designed to meet Cat5e performance, this cable supports data, voice and basic Power over Ethernet (PoE) in home and office environments. The green jacket helps with cable identification and management, while RJ-45 connectors on both ends enable straightforward plug-and-play installation.

Advantages

The cable features four pairs of 26 AWG stranded conductors arranged as twisted pairs to maintain a characteristic impedance of 100 ohm, ensuring stable signal transmission for typical Cat5e applications. Molded boots with kink protection and strain relief increase connector durability and reduce stress at the termination points. The unshielded design offers flexibility and ease of routing in conduit or cable trays, and the visible color simplifies network organization.

Suitable for

• Wired Ethernet connections between network devices such as routers, switches and PCs
• VoIP and voice/data installations in residential and small office networks
• Basic Power over Ethernet (PoE) powering of devices with low to moderate power draw
• Patch panel to switch or wall outlet patching in structured cabling

Key specifications

• Length: 10 m
• Cable category: Cat5e (UTP)
• Conductor: 4 pairs, 26 AWG stranded (26/7)
• Impedance: 100 ohm
• Connectors: RJ-45 male to RJ-45 male
• Jacket color: Green
• Connector features: Molded boots with kink protection and strain relief; spot length marking on boot

How to use

Plug one RJ-45 connector into the port of the network device and the other into the corresponding port of the second device, ensuring a secure click for a reliable connection. Route the cable to avoid sharp bends and excessive tension; use cable ties or cable management channels to maintain neat runs. For rack or panel installations, label both ends if required and allow some service loop to facilitate future moves or maintenance.

Recommendations

Use this Cat5e UTP cable for standard Ethernet speeds up to Gigabit where supported by network equipment, and avoid placing it alongside high-voltage power lines to reduce the risk of interference. For environments with significant electromagnetic interference or where higher performance is required, consider shielded cabling or a higher category cable.