Cable de red UTP Cat6 LOGON 15 m, RJ-45 a RJ-45, naranja

LOGON UTP Cat6 networking cable, 15 m length, with RJ-45 connectors at both ends. The cable conforms to Cat6 performance parameters for Gigabit Ethernet, providing a reliable physical layer for data transmission in home, office or small data-center environments. The solid orange jacket improves visibility and cable identification in patch panels and cable runs while the two RJ-45 male connectors allow straightforward plug-and-play connection to network devices.

Advantages

This Cat6 UTP cable supports higher bandwidth and improved signal integrity compared with lower category cables, enabling stable Gigabit Ethernet connections. The 15 m length covers typical short- to medium-run installations without additional patching. The molded RJ-45 plugs ensure a secure connection and the bright orange sheath simplifies tracing and cable management.

Suitable for

• Connecting desktop PCs, laptops and workstations to switches or routers
• Patching between switches and patch panels in small office racks
• Linking network devices such as printers, IP cameras and access points
• Temporary or permanent cabling where color-coded identification is useful

Key specifications

• Cable category: Cat6 UTP (unshielded twisted pair)
• Length: 15 m
• Connectors: RJ-45 male to RJ-45 male
• Color: orange outer jacket for visual identification
• Intended use: Ethernet networking up to Gigabit speeds over copper

How to use

Plug each RJ-45 connector into the corresponding Ethernet ports of your network devices, ensuring secure seating until the connector clicks. Route the cable to avoid sharp bends and areas with heavy EMI sources. For fixed installations, secure the cable along cable trays or walls using appropriate clips without compressing the jacket. Test the link with a network tester or by verifying network connectivity and speed from connected devices.

Recommendations

For best performance, avoid running this UTP cable parallel to mains power lines and keep bend radius greater than four times the cable diameter. Use straight-through wiring for device-to-switch connections; verify pinout compatibility when connecting to patched or custom-wired panels.