Cable de red UTP LANBERG LCU5-10CC-0100-S RJ45 100MB/S 100M Gris

The LANBERG LCU5-10CC-0100-S is a UTP network cable designed for structured cabling and Ethernet connections up to 100 Mb/s. Delivered on a 100-metre reel in grey, the cable uses CCA (Copper Clad Aluminium) conductors and standard RJ45-terminated compatibility for typical LAN installations. Its construction supports horizontal cabling in homes, offices and small server rooms where Fast Ethernet performance and flexible routing are required.

Advantages

This cable provides consistent 100 Mb/s data transmission over distances up to 100 metres and comes in a single long length that reduces the need for joins and patching. The CCA conductors offer a balance between conductivity and cost-effectiveness, while the UTP design keeps the cable flexible for easier installation in cable trays, conduits and along walls. The RJ45 compatibility ensures simple plug-and-play connection with common networking equipment.

Suitable for

• Fast Ethernet connections (100Base-TX) in home networks
• Office desktop networking and workstation cabling
• Horizontal cabling between patch panels and wall outlets
• Temporary or semi-permanent installations where long cable length is required

Key specifications

• Cable type: UTP (unshielded twisted pair)
• Conductor: CCA (Copper Clad Aluminium)
• Supported speed: up to 100 Mb/s
• Length: 100 metres
• Connector compatibility: RJ45
• Colour: grey
• Intended use: Ethernet (100Base-TX), horizontal cabling

How to use

Measure the required run and unspool the 100-metre reel, keeping the cable untwisted as much as possible near termination points. Terminate the cable with RJ45 plugs or punch down to patch panels and keystone jacks according to standard T568A or T568B wiring schemes. Route the cable through cable management systems, avoiding tight bends and sources of electrical interference. Test continuity and link speed after installation using a network cable tester or by verifying link negotiation with connected equipment.

Recommendations

For reliable performance, limit each continuous cable segment to 100 metres and avoid bundling large numbers of cables without separation from power lines. Use this cable for Fast Ethernet deployments; for Gigabit Ethernet or applications requiring higher shielding or lower attenuation, consider cables with solid copper conductors and higher performance categories.