Cable de red UTP LOGON Cat5e 1,5 m, RJ-45 a RJ-45, azul

LOGON UTP network cable Cat5e, 1.5 m with RJ-45 connectors at both ends, is designed for reliable Ethernet and LAN connections. The unshielded twisted pair (UTP) construction with four twisted pairs and 100 Ω impedance supports standard Cat5e signal transmission for broadband, local network and internet connections. The blue PVC jacket provides easy visual identification, while molded boots with kink protection and strain relief increase connector durability during frequent handling and use in tight spaces.

Advantages

This Cat5e patch cable offers a compact 1.5 m length that reduces excess cable clutter and signal degradation for short links such as between wall ports, patch panels, switches and desktop devices. The RJ-45 male connectors on both ends provide a simple plug-and-play connection compatible with common routers, switches, modems and network interface ports. The unshielded twisted pair design ensures consistent 100 Ω characteristic impedance and standard performance for Ethernet up to Cat5e specifications.

Suitable for

• Connecting desktop computers and networked devices to switches or wall outlets
• Patching between patch panels and network switches in racks
• Short Ethernet runs in home and small office environments
• Temporary or permanent connections for modems, routers and APs

Key specifications

• Length: 1.5 m
• Cable type: UTP, Category 5e
• Conductor: 4 pairs, 26 AWG (7-strand)
• Characteristic impedance: 100 Ω
• Connectors: RJ-45 male to RJ-45 male, molded boots with strain relief
• Jacket color: blue

How to use

Plug one RJ-45 connector into the network device or wall outlet and the other connector into the switch, router or modem port. Ensure connectors are fully seated until the locking clip engages. Avoid sharp bends near the connector boots and do not pull the cable by the cord; use the molded boot for handling. For rack or patch panel installations, route the 1.5 m cable to minimize tension and prevent kinks.

Recommendations

For best performance, keep the cable run within recommended distances for Cat5e installations and avoid running the cable parallel to high-voltage power lines. Use the short 1.5 m length for tidy patching or close-proximity connections; replace with higher-category cabling only where higher bandwidth or shielding is required.