Cable de red UTP QOLTEC 30 m Cat6 2×RJ45 negro

UTP patchcord cable QOLTEC 30 m Cat6 2×RJ45 black is a pre-terminated Ethernet cable designed for wired local area networks. The cable meets Category 6 performance characteristics suitable for Gigabit Ethernet and typical office or home networking environments. It comes with two RJ45 connectors and a flexible outer jacket to ease routing through cable trays, conduits and around equipment.

Advantages

The Cat6 construction provides improved crosstalk and noise reduction compared with lower category cables, ensuring reliable data transmission at higher frequencies. At 30 meters length the cable offers extended reach for connecting switches, routers, patch panels and end devices without intermediate splices. Pre-terminated RJ45 plugs allow immediate plug-and-play installation and reduce setup time, while the flexible black jacket helps conceal cabling and simplifies handling during runs.

Suitable for

Key specifications

How to use

Plug one RJ45 connector into the Ethernet port of a switch, router or wall outlet and the other end into the target device. Ensure connectors are fully seated and clipped into place to establish a reliable link. Route the cable to avoid sharp bends and sources of electromagnetic interference; secure with cable ties or cable management accessories as needed. For best performance, keep the run within the specified length and avoid tight coils or kinks.

Recommendations

For consistent Gigabit performance, use the patchcord for horizontal and patch connections within rack-mounted equipment and structured cabling. Avoid stretching, crushing or repeated flexing at connector ends. If routing through conduits or in environments with electrical noise, maintain separation from power cables and follow local cabling standards.