Cable DMX XLR de 5 pines PSSO 10 m con conectores Neutrik

Balanced 5-pin XLR DMX cable by PSSO, 10 meters long and fitted with Neutrik connectors. Designed for reliable transmission of DMX512 control signals between lighting consoles, fixtures and dimmers, this cable provides a stable digital link for stage, studio and event installations where low-noise signal transfer and robust connector performance are required.

Advantages

The cable combines balanced 5-pin XLR wiring with high-quality Neutrik connectors to reduce interference and ensure consistent contact. A 10 m length offers a practical reach for typical venue setups while maintaining signal integrity over distance. Durable outer sheathing and strain relief at the connector ends improve mechanical reliability in repeated live-use scenarios. The construction supports DMX512 protocol requirements for professional lighting control systems.

Suitable for

Key specifications

How to use

Connect the 5-pin Neutrik XLR male end to the DMX output of your lighting console and the female end to the DMX input of the first fixture, dimmer or splitter. If linking multiple fixtures, use the cable to daisy-chain from fixture to fixture following the equipment manufacturer’s input/output routing. Ensure connectors are fully seated and locked where applicable to prevent accidental disconnection during use. Observe proper DMX termination practices at the end of the chain when required to maintain signal stability.

Recommendations

Store the cable coiled without tight kinks and avoid sharp bends near the connectors. Inspect connector contacts and cable jacket regularly for wear; replace if shielding or connector integrity is compromised. For long-term touring or permanent installations, consider additional strain relief and secure routing to minimise mechanical stress and preserve DMX signal quality.