Cable Ethernet LOGON Cat6 UTP 20 m, RJ-45 a RJ-45, rojo

LOGON Cat6 UTP 20 m, RJ-45 to RJ-45, red is an unshielded twisted-pair Ethernet cable designed to support Gigabit Ethernet and high-speed data transmission over a 20-metre run. Built to Cat6 performance parameters with four twisted pairs and 100 Ω impedance, this cable suits structured cabling in homes, offices and network cabinets. The bright red jacket simplifies visual identification and routing in crowded cable installations.

Advantages

The cable provides reliable signal integrity for 250 MHz bandwidth applications thanks to Cat6 wiring and a 4×2 AWG 26/7 conductor configuration. Molded RJ-45 plugs on both ends include kink protection and strain relief to reduce connector stress and extend service life. The unshielded design keeps installation simple while meeting Category 6 performance requirements for stable Gigabit connections.

Suitable for

• Connecting switches, routers and patch panels in Ethernet networks
• Wiring workstations, printers and IP cameras over a 20 m distance
• Cable management and identification in server rooms or structured cabling

Key specifications

• Cable standard: Category 6 (Cat6) UTP
• Length: 20 m
• Conductors: 4 pairs, 26 AWG stranded (26/7)
• Characteristic impedance: 100 Ω
• Frequency rating: up to 250 MHz
• Connectors: RJ-45 plug — RJ-45 plug, 1:1 wiring
• Outer jacket color: red
• Connector features: molded boot with kink protection and strain relief
• Certification level: Category 6, 3P certified

How to use

Plug each RJ-45 connector into the corresponding Ethernet ports on your networking devices such as switches, routers or network interface cards. Route the cable to avoid sharp bends and areas of mechanical stress; the molded boots with strain relief help prevent damage at the connectors. For patch-panel installations, insert one end into the patch panel port and the other into the device or wall socket. Confirm link status and network speed on connected devices after installation.

Recommendations

To maintain performance, avoid running the cable parallel to high-voltage power lines and keep bend radius greater than the cable diameter. Use cable management accessories to secure runs and label both ends if used in multi-cable bundles for easier identification.