Cable óptico activo AOC SFP28 CBO BlueOptics BO272703Q2M 2M SFP28, 2 m de longitud

Active Optical Cable CBO AOC SFP28 BlueOptics BO272703Q2M 2M is a factory-terminated SFP28 form-factor link with a 2-metre cable length designed for short-reach high-speed interconnects. The cable integrates optical transceivers and a multimode fiber assembly within a single lightweight assembly, providing a direct 25GbE-compatible connection between servers, switches, and storage devices. As an AOC, it eliminates the need for separate transceivers and traditional copper twinax, offering lower power consumption and reduced electromagnetic interference while maintaining low latency for data centre and enterprise rack environments.

Advantages

The BlueOptics SFP28 AOC delivers a compact, plug-and-play solution that reduces installation complexity and saves rack space. Its active optical design ensures consistent signal integrity over the specified 2 m reach, with lower power draw compared to discrete transceiver-plus-cable combinations. The integrated assembly simplifies inventory and deployment by providing a single part that fits directly into SFP28 ports, avoiding manual fibre termination or optical alignment in the field.

Suitable for

• 25 Gigabit Ethernet short-reach links between servers and top-of-rack or leaf switches
• High-density switch-to-switch connections in data centre racks
• Direct uplinks for blade servers, storage arrays, and virtualised compute nodes
• Environments requiring low-latency, low-power interconnects with simplified cabling

Key specifications

• Form factor: SFP28 plug-and-play active optical cable
• Cable length: 2 metres
• Data rate support: 25 Gbit/s per lane (compatible with 25GbE)
• Connector type: SFP28 duplex optical connection (factory-terminated)
• Transmission medium: integrated optical fibre with active transceiver electronics
• Typical applications: short-reach server, switch, and storage interconnects in racks and data centres

How to use

Insert each SFP28 connector into the corresponding SFP28 port on the network devices until the latch engages. Ensure that both devices are powered off or allow hot-plugging per the equipment vendor's guidance. Verify link status through switch or server management interfaces and confirm negotiated speed and duplex settings. No separate transceivers or fibre termination are required; the cable is factory-terminated and ready for immediate use in compatible SFP28 ports.

Recommendations

Install the cable in tidy cable runs to avoid tight bends or pressure on the optical assembly; maintain the manufacturer’s minimum bend radius. Use within controlled rack environments and verify firmware and compatibility lists for network equipment to ensure full functionality. For long-term reliability, avoid exposing the cable to excessive heat, moisture, or mechanical stress during installation and operation.