Cable óptico activo CBO AOC SFP28 BlueOptics BO272703Q10M 10 m, SFP28 a SFP28, 25 Gbit/s

Active Optical Cable CBO AOC SFP28 BlueOptics BO272703Q10M is a 10 metre SFP28-to-SFP28 link designed to carry 25 Gbps signals between compatible ports. The AOC uses optical fibre with integrated transceivers in SFP28 housings to provide a plug-and-play connection that combines extended reach and electrical isolation compared with direct-attach copper solutions. It is intended for use in high-density data centre, server-to-switch and switch-to-switch interconnects where reliable, low-latency 25 Gbps connectivity is required.

Advantages

The active optical construction offers lower insertion loss over distance and immunity to electromagnetic interference, while remaining hot-pluggable in SFP28 slots. The 10 m length supports flexible rack and cabinet layouts without signal repeaters, and the optical link reduces ground-loop and common-mode issues inherent to copper cabling. The SFP28 form factor ensures compatibility with equipment that supports 25 Gbps SFP28 modules and simplifies installation with a standard transceiver interface.

Suitable for

• Server to switch connections in data centres
• Top-of-rack and end-of-row switch interconnects
• Storage area network links and high-performance computing clusters
• Environments requiring electrical isolation and reduced EMI

Key specifications

• Connector type: SFP28 to SFP28 optical transceiver housings
• Length: 10 metres
• Nominal data rate: 25 Gbps per channel
• Medium: multimode/mode appropriate optical fibre with integrated active optics
• Hot-pluggable SFP28 form factor
• Low latency link suitable for short-reach data centre interconnects

How to use

Install the cable by inserting each SFP28 connector into the corresponding SFP28 socket on your devices until the latch engages. Use supported 25 Gbps ports on switches, servers or storage equipment and verify link status through device management interfaces. No additional drivers are required for the passive interface; device firmware or operating system may report the transceiver type and link speed. When removing the cable, press the latch and pull straight out to avoid damaging the connector or device socket.

Recommendations

Avoid sharp bends and excessive tension on the optical cable; maintain the manufacturer’s recommended minimum bend radius and route the cable away from heat sources. Ensure both ends are fully seated and that connected equipment is configured for 25 Gbps operation. For mixed vendor environments, verify interoperability with device compatibility lists and update device firmware where necessary to ensure stable link negotiation.