Cable óptico BlueOptics QSFP BO252503K10M 10 m

BlueOptics QSFP Optical Cable BO252503K10M 10 m is a 10-metre multimode QSFP direct-attach-style fiber cable engineered for short-range, high-bandwidth connections between QSFP-capable ports. Designed to link switches, routers and transceivers in rack and data centre environments, the cable supports reliable, low-latency data transmission and simplifies physical layer setup for high-speed network paths.

Advantages

The cable offers a compact direct-attach form factor compatible with QSFP interfaces and is optimised for multimode short-reach links, enabling stable high-throughput connections without external transceivers. At 10 metres length it provides flexibility for rack-to-rack or within-rack deployments while keeping signal integrity for typical data centre distances. Built for compatibility and consistent performance, it reduces installation complexity and potential points of failure compared with discrete fiber-and-transceiver assemblies.

Suitable for

Key specifications

How to use

Install the BlueOptics QSFP cable by inserting each QSFP connector into the corresponding QSFP port until it seats securely. Ensure both devices are powered down or operate according to vendor hot-swap guidance if available, then verify link status indicators on connected equipment. Route the cable to avoid tight bends and abrasion; maintain recommended bend radius for multimode fibre to preserve signal quality. After physical connection, confirm configuration and link speed in the network equipment management interface.

Recommendations

Store and handle the cable following standard multimode fibre best practices: avoid sharp bends, kinks and crushing, keep connectors clean and capped when not in use, and use proper strain relief. For predictable performance, match the cable to QSFP ports designed for multimode short-reach links and verify transceiver compatibility if used with separate modules.