Cable SATA DeLOCK 84920 0,5 m SATA 22 pines negro naranja rojo amarillo

The DeLOCK 84920 is a 0.5 m SATA extension cable designed to extend both SATA data and power interfaces. It features SATA III specification compatibility and 22-pin SATA connectors on both ends, and is available in black, orange, red and yellow. The cable is supplied in a polybag and is intended for connecting internal SATA devices where an extension of the SATA connection is required.

Advantages

This SATA cable supports SATA III signalling for high-speed data transfer and uses standard 22-pin connectors for compatibility with a wide range of internal drives and controllers. At 0.5 m length it provides a short, tidy extension and is offered in multiple colours to help with cable identification and organisation inside the computer case.

Suitable for

• Extending internal SATA connections between motherboard and SATA drives
• Connecting 2.5" or 3.5" SATA HDDs and SSDs that require a 22-pin interface
• Reaching nearby drive bays or arranging cables for better airflow and organisation

Key specifications

• Cable type: SATA III
• Cable length: 0.5 m
• Connector 1: SATA 22-pin
• Connector 2: SATA 22-pin
• Product colours: Black, Orange, Red, Yellow
• Package: Polybag

How to use

Power down the system and disconnect from mains before installation. Locate the SATA connector on the motherboard or controller and the SATA connector on the target drive. Align the 22-pin connector with the drive’s SATA port and push gently until it seats. Connect the other end to the motherboard or SATA power connector as required. After connections are secure, restore power and verify that the drive is recognised by the system.

Recommendations

Use the cable for internal extensions only. Avoid excessive bending near the connector ends and route the cable to prevent interference with fans or other components. Verify SATA III compatibility of attached devices to achieve maximum transfer rates.