Cable SATA ShiverPeaks BS78241-0.5 0,5 m conector macho/conector macho negro rojo

The ShiverPeaks BS78241-0.5 is a 0.5m SATA cable with Male-to-Male connectors in black and red, intended for internal PC connections. It provides a direct link between storage devices such as hard drives or SATA SSDs and a motherboard or SATA controller. The cable length of 0.5 m suits compact cases and tight routing paths while maintaining reliable signal transmission for standard SATA interfaces.

Advantages

This SATA cable offers a compact 0.5 m form factor that reduces cable clutter and simplifies cable management inside the chassis. The male-to-male SATA connectors are compatible with standard SATA ports, enabling straightforward installation. The dual-color design (black and red) helps with visual identification of connections, and the build is intended to support stable, high-speed data transfer typical of SATA interfaces.

Suitable for

• Connecting 2.5" or 3.5" hard drives to a motherboard SATA port
• Connecting SATA SSDs to desktop or small form-factor PCs
• Internal cable routing in compact or mid-tower PC cases
• Replacing a damaged or worn SATA cable inside a computer

Key specifications

• Cable length: 0.5 m
• Connector type: SATA male to SATA male
• Colour: black and red
• Compatibility: standard SATA interfaces for HDD and SSD

How to use

Power off the system and disconnect it from the mains before connecting the cable. Align the SATA male connectors with the SATA ports on the drive and motherboard, ensuring the keyed connector orientation matches the port. Gently insert each end until it seats firmly without forcing. After installation, secure the drive and route the cable to avoid sharp bends and contact with moving parts such as fans. Restore power and verify drive detection in the BIOS or operating system.

Ieteikumi lietošanai

For stable operation, avoid tight bends and excessive pulling force on the cable. Use the 0.5 m length for short internal runs; if a longer routing is required, choose a longer cable to prevent strain on connectors. Regularly check connections if troubleshooting intermittent detection or data errors.