Cable SFP+ BlueOptics SFP-10G-C1M 1m conector/conector negro

The BlueOptics SFP-10G-C1M 1m Male/Male Black is a 1 meter SFP+ direct attach cable engineered for 10 Gigabit Ethernet interconnections. It provides a fixed, low-latency copper link with male SFP+ connectors on both ends, suitable for short-reach connections between switches, routers, servers and network interface cards in data centers and enterprise racks. The compact, black jacket and integrated connectors simplify installation while maintaining signal integrity for high-speed data transmission.

Advantages

This SFP+ cable offers a cost-effective, low-power alternative to optical transceivers for short distances, with minimal latency and consistent 10 Gbps throughput. The 1 m length reduces cable clutter and insertion loss compared with longer runs, and the standardized SFP+ male connectors ensure compatibility with a wide range of 10G-capable network equipment. Its lightweight construction and robust jacket provide reliable physical protection and ease of handling during rack installations.

Suitable for

Key specifications

How to use

Power down or follow hot-swap procedures recommended by your equipment vendor before inserting the cable. Align each male SFP+ connector with the SFP+ port and insert until it seats securely; follow any device-specific release mechanisms when removing the cable. Verify link status on connected devices and configure network settings as required for 10 Gbps operation. For best performance, avoid sharp bends and excessive strain on the cable and maintain proper airflow around connected equipment.

Recommendations

Use this 1 m SFP+ direct attach cable for short, high-bandwidth connections where optical modules are not required. Keep cable runs short, route clear of electromagnetic interference sources, and follow vendor compatibility lists if device interoperability is critical.