Cable USB 3.0 19 pines a USB 2.0 8 pines DeLOCK 83792 60 cm negro

This USB pin header cable by Delock converts a motherboard USB 3.0 19‑pin header to a USB 2.0 8‑pin header, allowing connection of USB 2.0 devices to a USB 3.0 header. The cable is approximately 60 cm long (without connectors) and comes in black. It provides power from the USB 3.0 header to connected USB 2.0 devices.

Advantages

The adapter supports data transfer rates up to 480 Mb/s and supplies up to 900 mA to connected USB 2.0 devices. It uses a standard USB 3.0 19‑pin female connector on the motherboard side and a USB 2.0 8‑pin male pin header on the device side. Compact cable length and black finish suit typical PC installations.

Suitable for

• Connecting USB 2.0 front‑panel ports or modules to a motherboard USB 3.0 header
• Adapting internal USB 2.0 devices to available USB 3.0 pin headers
• Case upgrades where internal USB 2.0 connectors must be routed to a USB 3.0 header

Key specifications

• Connector: USB 3.0 19‑pin female (motherboard) to USB 2.0 8‑pin male
• Data transfer rate: up to 480 Mb/s
• Power supply: up to 900 mA
• Cable length: approx. 60 cm (without connector)
• Colour: black

How to use

Connect the USB 3.0 19‑pin female end to the corresponding header on the motherboard, and attach the USB 2.0 8‑pin male connector to the device or front‑panel cable requiring a USB 2.0 header. Ensure proper pin alignment before applying power. Secure routing inside the case to avoid stress on the connectors.

Recommendations

Use this cable to connect standard internal USB 2.0 devices to an available USB 3.0 header; verify compatibility of the front‑panel or device connector and confirm the motherboard pinout matches the cable before installation.