Cable USB Renkforce Micro-USB Type-B en ángulo – USB 2.0 OTG, 5V 0,5A

The Renkforce angled Micro-USB Type B cable is a USB 2.0 connection cable designed for device-to-device links and charging where a right-angle plug improves fit and reduces strain on the device port. It supports OTG (On-The-Go) functionality, enabling compatible phones, tablets and peripherals to act as host or client. The cable is rated for 5 V and 0.5 A and uses the Micro-USB Type B connector in an angled housing to save space behind devices and to provide a lower-profile connection in tight setups.

Advantages

The angled Micro-USB connector reduces mechanical stress on ports and cabling, making it suitable for installations with limited clearance. OTG support allows direct connection of peripherals such as USB flash drives, keyboards or mice to compatible mobile devices without a PC. Compliance with USB 2.0 ensures standard data transfer and charging behaviour at the specified voltage and current rating.

Suitable for

• Charging compatible phones and small tablets at up to 5 V / 0.5 A
• Connecting USB OTG peripherals (flash drives, input devices) to OTG-capable mobile devices
• Use in installations with limited rear clearance where a straight connector would bend
• Connecting small peripherals such as GPS units, Bluetooth adapters or MP3 players that use Micro-USB Type B

Key specifications

• Connector type: Micro-USB Type B angled (right-angle)
• USB standard: USB 2.0 (supports standard USB 2.0 signaling)
• Functionality: OTG (On-The-Go) capable
• Electrical rating: 5 V, 0.5 A
• Cable orientation: right-angle connector to reduce strain and save space
• Typical uses: data transfer and low-current charging

How to use

Insert the angled Micro-USB Type B plug into the device's Micro-USB port with the connector oriented to suit the available space. For OTG use, enable OTG functionality on the host device if required by the operating system; then connect the peripheral to the cable. Observe the 5 V/0.5 A electrical rating: this cable supports data transfer and low-current charging but is not intended for high-current fast charging. Ensure connectors are fully seated and avoid excessive bending at the cable entry to prolong connector and port life.

Lietošanas ieteikumi

Use the cable with devices that explicitly support Micro-USB OTG and adhere to the 5 V/0.5 A current limitation. Avoid using the cable with high-current chargers or adapters. When connecting in tight spaces, position the angled plug so it does not place lateral pressure on the device port. Disconnect by pulling the connector body rather than the cable to prevent damage.