Cable XLR de 3 pines PSSO 10 m con conectores Neutrik

The XLR cable 3-pin PSSO 10 m with Neutrik connectors is a balanced audio cable intended for professional audio connections. At 10 meters length it supports microphone, instrument and line-level signals while maintaining signal integrity over longer runs. The cable uses industry-standard 3-pin XLR wiring and is fitted with Neutrik male and female connectors that provide a secure locking mechanism for stable connections in live sound, studio and broadcast environments.

Advantages

This balanced XLR cable reduces susceptibility to electromagnetic interference and ground loop noise through its twisted pair and shielding design, delivering consistent signal transmission across the full 10 m length. Neutrik connectors add mechanical durability and reliable contact, helping to prevent accidental disconnections during performances or recording sessions. The cable’s construction is designed to provide predictable impedance and low signal loss, suitable for both low-level microphone signals and line-level sources.

Suitable for

Key specifications

How to use

Connect the male XLR end to the input of the receiving device (mixer, preamp, interface) and the female XLR end to the output source (microphone, DI box, stage box). Ensure connectors are fully inserted until the locking latch engages to secure the connection. Route the cable away from power cables and noisy electronics to minimize interference, and avoid tight bends or kinks that may stress the conductors or connector strain relief.

Recommendations

Inspect connectors periodically for dirt or oxidation and clean contacts with appropriate contact cleaner if necessary. For long-term reliability, coil the cable using an over-under technique when storing, and avoid pulling on the cable to disconnect—press the release latch on the Neutrik connector. Use cable ties or gaffer tape to secure runs on stage and reduce trip hazards.