CBO AOC SFP28 BlueOptics BO272703Q10M Cable óptico activo de 10 m, SFP28

The CBO AOC SFP28 BlueOptics BO272703Q10M 10M active optical cable is a fixed SFP28-form-factor connection cable designed for high-speed links between SFP28 ports in switches, servers and storage systems. With a 10 metre length and integrated optical transceivers, this active optical cable delivers low-latency, low-power 25GbE connectivity while remaining compatible with 10GbE links as required. The integrated design removes the need for separate transceivers, reducing rack footprint and simplifying cable management in data centre and rack-to-rack deployments.

Advantages

The cable provides a vendor-compatible AOC solution that offers stable signal integrity over 10 metres with minimal electromagnetic interference and lower power consumption compared with equivalent copper direct attach options. Its SFP28 form factor ensures direct hot-pluggable compatibility with SFP28 ports, enabling fast installation and predictable performance. The integrated optics and fixed length simplify inventory and reduce the number of serviceable components.

Suitable for

• 25GbE interconnects between top-of-rack switches and aggregation switches
• Server-to-switch connections in high-density rack environments
• Storage system links requiring low latency and consistent throughput
• Short-reach data centre and rack-to-rack links where fixed, vendor-compatible AOC is preferred

Key specifications

• Form factor: SFP28 active optical cable with integrated transceivers
• Supported speeds: native 25GbE with backward compatibility to 10GbE
• Length: 10 metres
• Latency: low-latency optical transmission suitable for server and storage traffic
• Power: lower power consumption compared with equivalent copper direct-attach cables
• Compatibility: designed for direct use in SFP28 ports without separate transceivers

How to use

Install the AOC by inserting each SFP28 connector into the corresponding SFP28 port on the two devices to be linked. Ensure both devices support SFP28 modules and that firmware or vendor compatibility requirements are met before deployment. The cable is hot-pluggable; after seating the connectors, the devices should detect the link and negotiate the appropriate speed (25GbE or 10GbE). For best results, route the cable to avoid tight bends and secure it to prevent strain on connectors.

Recommendations

Use this active optical cable in short-reach data centre links where a fixed-length, low-power, SFP28-compatible solution simplifies cabling. Avoid exceeding manufacturer-recommended bend radii, and verify compatibility with switch and server vendor platforms if strict vendor-lock compatibility is required.