CBO AOC SFP28 BlueOptics BO272703Q50M 50m Cable Óptico Activo para Puertos SFP28

The CBO AOC SFP28 BlueOptics BO272703Q50M 50m active optical cable for SFP28 ports is a factory-terminated optical link designed for 25Gbps short-reach connections between network devices. It integrates optical fibre and active transceiver electronics into a single cable assembly compatible with SFP28 ports, eliminating the need for separate transceivers and copper patching. The 50 meter length supports elevated channel distances within data centres and server rooms while maintaining low latency and electrical isolation.

Advantages

This active optical cable offers a compact, plug-and-play solution that reduces rack space and simplifies installation compared with discrete transceivers and fibre patch cords. It provides predictable 25Gbps performance with low insertion loss and immunity to electromagnetic interference because the optical link provides electrical isolation. The integrated design lowers component count and can improve signal integrity across mid-range interconnect distances.

Suitable for

• Inter-switch links in data centres and enterprise networks
• Server-to-switch and storage-to-switch connections
• High-density rack cabling where active optical assembly saves space
• Environments requiring EMI immunity and electrical isolation

Key specifications

• Form factor: SFP28-compatible active optical cable
• Data rate: 25 Gbps per channel
• Cable type: Active optical fibre assembly with integrated transceiver electronics
• Length: 50 metres
• Connector interface: SFP28 plug on both ends
• Latency: low propagation latency suitable for switch and server interconnects
• Electrical characteristics: provides galvanic isolation between connected devices
• Application environment: designed for data centre and server room use

How to use

Install the cable by inserting each SFP28 plug into the corresponding SFP28 slot on the networking equipment until the latch clicks. Ensure both devices support SFP28 AOC modules and are powered off or follow hot-plug procedures recommended by the equipment vendor. Verify link status and negotiated speed through device management interfaces. Route the cable to avoid sharp bends and maintain recommended bend radius to preserve optical performance.

Recommendations

Handle with care during installation: avoid tight bends, excessive tensile load and exposure to liquids or contaminants. Use the cable for 25Gbps links within racks or between adjacent rows where 50 metres covers the required distance. Confirm compatibility with your switch and server vendor documentation for supported AOC assemblies and check link diagnostics after installation.