CBO AOC SFP28 BlueOptics BO272703Q5M cable óptico activo 5 m

The CBO AOC SFP28 BlueOptics BO272703Q5M active optical cable 5 m is a factory-terminated SFP28-compatible optical direct-attach link designed to connect SFP28 ports on servers, switches and network interface cards. This 5-metre active optical cable supports 25 Gbps per channel with an optical interface that removes the need for separate transceivers, enabling straightforward plug-and-play installation for short-reach links in data centres, server racks and high-density switch interconnects.

Advantages

The BlueOptics active optical cable provides high-bandwidth 25 Gbps performance with low latency and reduced power consumption compared with equivalent copper twinax solutions. The integrated optical transceiver design simplifies cabling and reduces components, lowering installation time and physical complexity. With a flexible cable assembly and robust connector housings, the cable is suitable for dense rack environments and helps maintain signal integrity over the 5 m link length.

Suitable for

• 25GbE links between switches and servers within a rack or between adjacent racks
• High-performance computing clusters requiring low-latency interconnects
• Top-of-rack and spine switch interconnection in data centres
• Network interface card (NIC) to switch connections for storage and virtualization hosts

Key specifications

• Connector type: SFP28 form-factor plug on both ends
• Data rate: 25 Gbps per channel
• Cable type: active optical cable (AOC) with integrated transceivers
• Length: 5 metres
• Typical application: short-reach data centre and rack-level interconnects
• Power profile: lower electrical power consumption compared with equivalent copper direct-attach cables

How to use

Install the BlueOptics SFP28 active optical cable by inserting each SFP28 plug into the corresponding SFP28 port until the latch engages. Ensure devices are powered down or support hot-plugging per the equipment vendor’s guidelines. After insertion, verify link status on connected devices and confirm operational speed and duplex as reported by the switch or host interface. Route the cable to avoid sharp bends and secure it within the rack to prevent strain on connectors.

Recommendations

For reliable operation, maintain the minimum bend radius specified by the manufacturer, avoid exposure to excessive tension or crushing, and use the cable for short-reach 25GbE applications in controlled data centre environments. Verify compatibility with the SFP28 ports on your equipment and consult device documentation for any required firmware or compatibility settings.