CBO AOC SFP28 BlueOptics BO272703Q7M 7m Cable Óptico Activo, SFP28 a SFP28, 25 Gbit/s, 7 m

CBO AOC SFP28 BlueOptics BO272703Q7M is a 7 m active optical cable with SFP28 connectors on both ends supporting 25 Gbps data rates. The cable is intended for high-speed interconnects between servers, switches and storage equipment in data centre and rack environments. As an active optical cable, it integrates optical transceivers and a fixed optical fibre in one assembly, offering a simplified single-cable solution compared with separate transceivers and patch cords while providing low latency and immunity to electromagnetic interference.

Advantages

The 7 metre active optical cable delivers a reliable 25 Gbps link over a compact, pre-terminated assembly that reduces installation time and eliminates the need to handle separate fibre connectors and transceivers. Its integrated design lowers signal loss and ensures consistent performance across the full length. The cable provides EMI immunity for use in dense rack installations and supports hot-pluggable SFP28 form-factor connectivity, enabling straightforward replacement and upgrades without powering down equipment.

Suitable for

• Server-to-switch high-speed links in data centres
• Switch-to-switch interconnects within equipment racks
• Storage arrays and network-attached storage connections
• Top-of-rack and end-of-row cabling where 7 m reach is required

Key specifications

• Connector type: SFP28 to SFP28
• Maximum data rate: 25 Gbps
• Cable length: 7 metres
• Cable type: Active optical cable (integrated transceivers and fibre)
• Latency: low, suitable for high-performance networking
• Electromagnetic compatibility: immune to EMI by design
• Form factor: hot-pluggable SFP28

How to use

Install the cable by inserting each SFP28 connector into the corresponding SFP28 port on your networking devices until the module latches. No separate transceivers or patch cords are required. Ensure the devices support 25 Gbps SFP28 connectivity and that port settings match the desired link speed and protocols. Route the cable within the rack to avoid sharp bends and secure it with cable management to maintain minimum bend radius. When unplugging, depress the latch mechanism before withdrawing the connector to avoid damage.

Recommendations

Use this active optical cable in indoor, controlled data centre environments and avoid exposure to excessive mechanical stress or liquids. Verify firmware or driver support for SFP28 active optical modules on both endpoints to ensure link stability at 25 Gbps.