Cinta antideslizante Tesa 60953-00000-00, 15 m x 25 mm, fluorescente

Tesa anti-slip tape 60953-00000-00 is a fluorescent self-adhesive safety tape measuring 15 m in length and 25 mm in width. Designed to improve traction on slippery surfaces and to mark edges and hazards, this tape combines a high-visibility fluorescent layer with a textured, slip-resistant surface. The narrow roll is easy to cut and apply to a variety of clean, dry substrates, providing immediate grip and enhanced visibility in low-light conditions.

Advantages

The fluorescent color increases visibility in dim environments and during power outages, while the textured surface reduces the risk of slipping. The self-adhesive backing enables quick installation without additional tools, and the flexible strip conforms to slightly curved or uneven surfaces. Its compact width makes it suitable for precise applications along stair nosings, ramps and walkways.

Suitable for

• Stair nosings and treads in public buildings and homes
• Ramps, gangways and inclined walkways
• Industrial floors and work platforms
• Marking edges of steps, thresholds and doorways
• Temporary or permanent safety markings in low-light areas

Key specifications

• Length: 15 m
• Width: 25 mm
• Color: Fluorescent (high-visibility)
• Adhesive type: Self-adhesive backing for direct application
• Surface: Textured, slip-resistant top layer
• Application temperature: Suitable for application on clean, dry surfaces (follow manufacturer guidance for temperature range)

How to use

Measure and cut the required length of tape with scissors or a utility knife. Ensure the surface is clean, dry and free from grease, dust and loose particles. Peel off the protective liner and press the tape firmly onto the substrate, smoothing out any air pockets. For best adhesion, apply even pressure along the entire length and allow the adhesive to set before exposing to regular foot traffic. When applying on corners or curved surfaces, make small relief cuts or overlap carefully to maintain contact.

Recommendations

For durable results, clean surfaces with a suitable solvent or detergent and allow full drying before application. Avoid applying the tape to damp, contaminated or highly textured surfaces that may prevent full adhesive contact. Replace the tape when wear reduces traction or when the fluorescent visibility diminishes. For critical safety installations, verify compatibility with the specific substrate and consult local safety standards.