Conector para tira LED 2 polos EUROLITE 50530079 para tira LED de 10 mm

EUROLITE 50530079 2-pin LED strip connector is designed for reliable mechanical and electrical joining of 10 mm wide, two-conductor LED strips without the need for soldering. The compact connector enables quick extension, repair or linking of LED strip segments in installations where a simple, non-permanent connection is required. It is compatible with common flexible 10 mm LED modules used in residential, retail and display lighting.

Advantages

The connector allows tool-free assembly and avoids heat or flux from soldering, reducing installation time and the risk of damage to delicate LED strips. Its two-pin design ensures correct polarity alignment and consistent electrical contact for standard two-conductor LED strips. The small form factor makes it suitable for concealed joints and tight spaces while providing a secure mechanical grip on the LED strip conductors.

Suitable for

Key specifications

How to use

Prepare the LED strip by cutting along the marked cut line and ensuring the copper contact pads are clean and free of adhesive residue. Open the connector mechanism, insert the strip fully so that the copper contacts align with the connector pins, then close or press the connector to secure the strip and establish electrical contact. Verify correct polarity before powering the circuit and test the connection with low voltage to confirm continuity and function.

Recommendations

Use this connector with LED strips of the specified width and conductor layout only. Avoid exposing the connection to moisture or mechanical stress unless additional sealing or strain relief is applied. For permanent outdoor or wet-location installations, consider using waterproof connectors or encapsulation methods designed for environmental protection.