Conector para tira LED 3 polos 10 mm para tiras LED EUROLITE, modelo 50530065

This 3‑pin 10 mm LED strip connector from EUROLITE (model 50530065) is designed to join compatible 10 mm wide LED strips that use a three‑contact layout. The connector enables a reliable electrical and mechanical connection without soldering, allowing quick repairs, extensions or custom LED installations. Its compact housing and tool‑friendly design simplify installation in tight spaces and on existing lighting assemblies.

Advantages

The connector provides a solderless, low‑effort method to join LED strips while maintaining correct polarity and stable contact across three channels. Built for rapid installation, it reduces downtime during maintenance and enables easy reconfiguration or extension of LED runs. The compact form factor helps preserve the strip profile and fits standard 10 mm LED tape widths, supporting tidy and consistent connections.

Suitable for

Key specifications

How to use

Prepare both ends of the LED strip by ensuring the copper pads are clean and free of adhesive residue. Open the connector housing, align the strip so that each copper contact sits on its corresponding contact in the connector, and firmly close the housing until it locks. Visually confirm correct polarity alignment before powering the strip. For secure mechanical hold, press until an audible or tactile click indicates the clamp is engaged. When removing, unlock gently to avoid damaging the strip pads.

Recommendations

Use the connector only with compatible 10 mm wide, 3‑pin LED strips and in dry indoor conditions. Verify voltage and current compatibility of the LED strip and power supply before connecting. Avoid repeated open/close cycles at the same spot to prevent wear on the copper pads; for permanent installations consider reinforcing the joint with tape or adhesive suitable for electronics.