Creality ENDER-3 V3 SE Motor paso a paso 42-26 (3204120100)

When your Creality 3D printer starts skipping steps or losing position, the culprit is often a worn or underpowered stepper motor. The Creality ENDER-3 V3 SE 42-26 Stepper Motor restores precise motion control to your printer's X, Y, or Z axis. This bipolar stepper motor features a NEMA 17 frame size and a 26 mm body length, making it a direct replacement for the motor used in the Ender-3 V3 SE and compatible with other Creality models.

Who is it for

This motor is for 3D printing enthusiasts and professionals who need to replace a faulty stepper motor or upgrade their Creality printer for reliable, accurate movement. It is compatible with the Ender-3 V3 SE, Ender-3 S1, CR-6 SE, and other Ender-3 and CR-10 series printers.

Main features

• NEMA 17 frame size (42 mm x 42 mm) with 26 mm body length
• 1.8° step angle for precise positioning
• Holding torque of 0.26 N·m (26 N·cm)
• Rated current 1.5 A per phase, rated voltage 2.55 V
• D-cut shaft with 5 mm diameter
• 4-pin JST-XH 2.54 mm connector for easy installation

Specifications

• Motor Type: Bipolar Stepper Motor
• Frame Size: NEMA 17 (42 mm x 42 mm)
• Step Angle: 1.8°
• Number of Phases: 2
• Rated Voltage: 2.55 V
• Rated Current: 1.5 A/Phase
• Holding Torque: 0.26 N·m (26 N·cm)
• Phase Resistance: 1.7 Ω ± 10%
• Phase Inductance: 2.5 mH ± 20%
• Rotor Inertia: 38 g·cm²
• Motor Body Length: 26 mm
• Shaft Diameter: 5 mm
• Shaft Type: D-cut
• Number of Leads: 4
• Connector Type: JST-XH 2.54 mm 4-Pin
• Operating Temperature: -10°C to 50°C

Tips

Before installing, ensure the printer is powered off and disconnected. Check that the motor's connector matches your printer's wiring; if not, you may need an adapter. After installation, verify the axis moves smoothly and recalibrate if necessary.