Destornillador manual Wiha 36540 Single destornillador estándar

Manual screwdriver Wiha 36540 Single Standard screwdriver with an insulated slim blade and ergonomic SoftFinish® handle. The tool is manufactured from chrome-vanadium-molybdenum steel with a black finish and is individually tested for electrical safety. It is suitable for work on live parts up to 1,000 V AC and complies with DIN ISO 8764-PH and IEC 60900 standards.

Advantages

Wiha slim blade design provides protected access to deep-set screws. The patented SoftFinish® handle reduces strain on hands and muscles and is recommended by specialists at the German Campaign for Healthier Backs. The handle-length concept offers an optimal balance between torque and control. Each screwdriver is electrically tested at 10,000 V AC and approved for safe use up to 1,000 V AC.

Suitable for

Key specifications

How to use

Select the Wiha 36540 insulated screwdriver for tasks involving live electrical parts up to 1,000 V AC. Grip the SoftFinish® handle and use the slim blade to reach recessed screws. Apply controlled torque using the handle-length balance to tighten or loosen screws without excessive force. After use, store the insulated screwdriver in a dry, clean place to preserve the insulation and blade condition.

Recommendations

Only use this insulated screwdriver on live parts when it is in good condition and the insulation is intact. Do not use the tool if the handle or blade is damaged. Follow local safety regulations and switch off power where possible before performing work.