Destornillador manual Wiha 38610 Destornillador multibit Destornillador combinado

The Wiha 38610 LiftUp electric multi-bit screwdriver combines a compact bit magazine in the handle with individually tested VDE insulation to provide a practical tool for electricians. The handle stores six 75 mm slimBits that extend from the magazine at the press of a button and are gripped securely by the ClicFix holder. The slender insulated slimBits allow access to deep or low-lying screws and spring clips, while the twistable end cap improves handling. The tool is manufactured according to IEC 60900 and is approved for work on live parts up to 1,000 V AC when used as intended.

Advantages

The integrated LiftUp electric bit magazine reduces transport volume and weight compared with a set of individual screwdrivers, while keeping all bits readily available. All blades are stored safely inside the handle to reduce the risk of injury. Each tool and its bits are individually tested at 10,000 V AC and certified for safe use up to 1,000 V AC according to IEC 60900. The ClicFix holder secures bits reliably and converts the magazine into a fully functional screwdriver.

Suitable for

• Electrical installation and maintenance on live parts up to 1,000 V AC
• Fieldwork for electricians and service technicians
• Fast access to deep-set or recessed screws and spring clips

Key specifications

• Brand: Wiha
• Model: 38610 (LiftUp electric)
• Stored bits: 6 slimBits, 75 mm length
• Insulation and standard: manufactured and tested to IEC 60900; individually tested at 10,000 V AC, approved for 1,000 V AC
• Weight: 0.162 kg
• Included bit types: Phillips and slotted tips (multi-bit configuration)
• Note: Not compatible with bit styles C 6.3 and E 6.3; 6 mm slimBits only for use in slimVario® and slimTorque VDE bit holders

How to use

Press the release on the LiftUp magazine to extend the selected slimBit from the handle. Insert the bit into the ClicFix holder until it locks. Use the screwdriver on live parts only within the certified limit of 1,000 V AC and follow applicable safety procedures. To change bits, press the magazine release and remove the bit, then select another slimBit from the handle store and lock it into the ClicFix holder. Do not use incompatible bit styles (C 6.3, E 6.3) or use 6 mm slimBits outside the specified VDE holders.

Recommendations

Use the Wiha 38610 LiftUp electric only for tasks within its IEC 60900 rating; keep bits stowed when transporting the tool and check the condition of insulation regularly. Avoid using incompatible bit styles and follow local electrical safety regulations when working on live circuits.