Disipador CPU Silentware Bora RGB blanco con ventilador PWM-ARGB de 120 mm, 215 W TDP, compatible con AM5 y LGA1851

Silentware Bora RGB White is an air CPU cooler with a 120mm PWM-controlled ARGB fan and a rated 215W TDP. Engineered for compatibility with AM5 and LGA1851 sockets, the cooler uses a compact tower design and a single high-performance fan to provide active heat dissipation for modern desktop processors. The PWM control adjusts fan speed automatically according to CPU temperature, while the ARGB lighting supports motherboard-synchronized customization for a coordinated system appearance.

Advantages

The design balances thermal performance and acoustic levels, delivering up to 215W of cooling capacity with a focus on quiet operation. The 120mm PWM fan allows variable speed control to reduce noise during light loads and increase airflow under heavy workloads. ARGB illumination adds visual customization without affecting cooling efficiency. The cooler’s mounting system supports both AM5 and LGA1851 platforms for straightforward installation in a broad range of systems.

Suitable for

• Gaming desktops with mid- to high-power CPUs
• Home and office workstations requiring stable cooling under load
• Compact tower builds where a single 120mm cooler meets clearance constraints
• Systems where synchronized ARGB lighting is desired

Key specifications

• Cooling type: air cooler with single 120mm fan
• Fan control: PWM (automatic speed regulation)
• Lighting: ARGB compatible with motherboard sync
• Thermal capacity: rated up to 215W TDP
• Supported sockets: AM5 and LGA1851
• Form factor: compact tower suitable for standard mid-tower cases

How to use

Mount the Silentware Bora RGB White following the included instructions for the target socket type (AM5 or LGA1851). Apply a thin, even layer of thermal paste to the CPU heat spreader, position the cooler so the base contacts the CPU, and secure the mounting brackets to the motherboard standoffs. Connect the 4-pin PWM fan header to the CPU_FAN or SYS_FAN header for automatic speed control and plug the ARGB connector into a compatible header or controller to enable lighting effects. Verify clearances around memory modules and case panels before completing installation.

Recommendations

For best results, ensure good case airflow with at least one intake and one exhaust fan, monitor CPU temperatures after installation to confirm the PWM control profile, and keep the fan and heatsink free of dust. Use motherboard software or an ARGB controller to configure lighting and fan curves according to workload and noise preference.