Disparador inalámbrico AVTEK 1EVA11 para pantallas de proyección eléctricas — receptor de mando a distancia

Wireless trigger AVTEK 1EVA11 for electric projection screens — remote control receiver is a compact receiver module designed to control motorized projection screens without direct wiring. It works with compatible AVTEK transmitters that use the same 1EVA11 interface, enabling remote raising and lowering of screens and simplifying installation in classrooms, conference rooms and home cinema setups.

Advantages

The receiver offers a compact form factor that fits behind a screen housing or inside AV cabinets, reducing visible hardware and maintaining a clean installation. Wireless operation removes the need for additional control cabling, which speeds up setup and reduces labor. The unit is compatible with AVTEK transmitters that follow the 1EVA11 interface, providing consistent and reliable command transmission for screen up/down functions. Low power consumption and simple pairing procedures make it convenient for permanent or temporary installations.

Suitable for

• Motorized projection screens in classrooms and lecture halls
• Conference rooms and meeting spaces with AV setups
• Home theater and private screening rooms
• Multi-screen installations where centralized wireless control is preferred

Key specifications

• Function: wireless receiver for controlling electric projection screens (up/down)
• Compatibility: designed for use with AVTEK transmitters using the 1EVA11 interface
• Form factor: compact module suitable for mounting inside screen housings or AV enclosures
• Operation: wireless remote command reception for motorized screen control
• Power: low power consumption suitable for continuous standby and operation

How to use

Install the receiver inside the projection screen housing or in a nearby AV enclosure and connect it to the screen’s control input following the screen manufacturer’s wiring. Pair the receiver with a compatible AVTEK transmitter according to the supplied pairing procedure: typically this involves placing both devices into pairing mode and confirming successful link formation. After pairing, use the transmitter to send up and down commands to operate the screen remotely. Ensure the receiver is positioned to receive the transmitter’s signal without obstruction for reliable performance.

Recommendations

Place the receiver where it will receive a clear line-of-sight signal from the transmitter when possible, avoid placing it behind large metal objects or deep inside dense enclosures that could attenuate RF signals. Follow the projection screen manufacturer’s wiring and safety instructions when connecting the receiver, and verify proper operation after installation by testing full travel limits and remote commands.