eSUN PLA+ 1,75mm verde 1kg recarga filamento 3D (PLA+175G1R1)

For makers who need more than standard PLA, eSUN PLA+ in Green delivers an upgraded formula with higher toughness, better layer adhesion, and reduced warping. This 1 kg refill spool keeps your printer fed without adding plastic waste, and the 1.75 mm diameter with ±0.03 mm tolerance ensures consistent extrusion on any FDM printer.

Highlights

• Enhanced PLA+ material: 50–70 MPa tensile strength and 10–20% elongation at break for durable, impact-resistant prints.
• Precision diameter: 1.75 mm ±0.03 mm, vacuum sealed with desiccant to prevent moisture and bubbles.
• Refill format: spool-less design reduces waste and works with reusable spools or holders.
• Reliable printing: 200–230 °C nozzle, 45–60 °C bed, speeds up to 100 mm/s, low odor and biodegradable.

In daily use

Load the refill onto your existing spool, set your slicer for PLA+ profiles, and print functional parts, prototypes, or display models. The green colour is vivid and consistent, and the material's low warping means you can print large flat parts with confidence. Good layer adhesion reduces delamination, so your prints hold up under stress.

Full specifications

• Material: eSUN PLA+ (Polylactic Acid Plus)
• Filament diameter: 1.75 mm
• Diameter tolerance: ±0.03 mm
• Colour: Green
• Net filament weight: 1 kg
• Spool type: Refill (spool-less)
• Recommended nozzle temperature: 200–230 °C
• Recommended bed temperature: 45–60 °C
• Recommended print speed: 40–100 mm/s
• Tensile strength: 50–70 MPa
• Elongation at break: 10–20%
• Density: 1.24 g/cm³
• Melt flow index: 3–5 g/10 min (190 °C, 2.16 kg)
• Vicat softening temperature: ≥60 °C
• Heat deflection temperature: ≥55 °C (0.45 MPa)
• Bubble: 100% no bubble
• Compatibility: FDM 3D printers
• Packaging: Vacuum sealed with desiccant

Final note

eSUN PLA+ Green refill gives you professional-grade toughness and printability in an eco-conscious format—perfect for high-quality, durable prints without the extra spool waste.