Filamento Elegoo PLA-CF 1,75 mm negro 1 kg

ELEGOO PLA-CF (polylactic acid reinforced with carbon fiber) is a 1.75 mm composite filament supplied on a 1 kg spool. It combines the easy printability of PLA with increased stiffness and reduced shrinkage thanks to carbon fiber reinforcement, producing durable, dimensionally accurate parts with a natural matte finish. The filament is suitable for most FDM/FFF 3D printers with a 1.75 mm feed and is intended for functional prototypes, housings and technical components that require higher rigidity while remaining lightweight.

Advantages

The carbon-fiber-doped PLA reduces warping and deformation, improving dimensional precision and part fit. Prints show a matte surface with subtle layer lines for a professional look without extensive post-processing. The filament is vacuum-sealed with a desiccant to limit moisture absorption and has a diameter tolerance of ±0.02 mm for reliable feeding and fewer jams. It prints well alone or blended with standard PLA where compatible.

Suitable for

• Functional prototypes and mechanical parts
• Durable housings and enclosures
• Lightweight structural components
• Technical models requiring dimensional accuracy

Key specifications

• Brand: ELEGOO
• Model (MPN): 50.203.0464
• EAN: 6932704908495
• Material: PLA with carbon fiber
• Diameter: 1.75 mm (tolerance ±0.02 mm)
• Spool weight: 1 kg
• Color: Black
• Density: 1.24 g/cm³
• Melting point: 165°C
• Nozzle temperature: 210–240°C
• Print bed temperature: 35–65°C (depending on printer and surface)
• Recommended drying: 55 ± 5°C
• Maximum recommended printing speed: <300 mm/s

How to use

Store the vacuum-packed spool with the included desiccant until ready to print. If the filament has absorbed moisture, dry it at about 55 ± 5°C before printing. Load the 1.75 mm filament into an FDM/FFF printer and set the nozzle temperature between 210 and 240°C and the bed temperature between 35 and 65°C depending on your printer and build surface. Use a textured PEI or another compatible surface for good adhesion. Print speeds below 300 mm/s are recommended; adjust retraction and cooling to suit your model and printer.

Recommendations

To minimize nozzle wear from carbon fibers, use a hardened or steel nozzle and avoid excessive retraction. Keep filament dry and use recommended temperatures and a suitable build surface for best dimensional accuracy and surface finish.