Fischer FIS V Plus 360 S mortero de inyección de alto rendimiento, 8 cartuchos

FISCHER FIS V Plus 360 S is a high-performance injection mortar supplied as a set of eight 360 ml cartridges in grey and delivered in a passive cool box. The ready-to-use two-component resin system is intended for anchoring and bonding in concrete and masonry. The cartridge format fits standard dispensing guns, enabling controlled mixing and accurate dosing for structural and non-structural fixings where chemical anchoring is required. The passive cool box protects cartridges from temperature fluctuations during transport and short-term storage.

Advantages

The system provides reliable bond strength in cracked and non-cracked concrete as well as in solid and hollow masonry. Its cartridge design ensures precise metering and homogeneous mixing through static mixers, reducing waste and application errors. Delivered in a passive cool box, the product is easier to handle on site and maintains consistent material properties until use. The grey colour simplifies visual inspection of applied material without affecting curing performance.

Suitable for

• Anchoring threaded rods and rebar in concrete
• Fixing heavy-duty fixtures to masonry and blockwork
• Installation of structural and non-structural mechanical fasteners
• Applications requiring chemical anchoring in indoor and sheltered outdoor locations

Key specifications

• Package contents: eight 360 ml cartridges
• Product form: two-component injection mortar in cartridge format
• Colour: grey
• Delivery: passive cool box for transport and short-term temperature protection
• Compatibility: suitable for use with standard caulking/dispensing guns and static mixers
• Suitable substrates: concrete (cracked and non-cracked), solid and hollow masonry

How to use

Prepare the substrate by cleaning drill holes of dust, debris and grease following relevant standards and site requirements. Fit the cartridge into a compatible dispensing gun and attach the appropriate static mixer. Dispense and discard initial material until uniform colour and consistency are achieved, then inject the mortar from the back of the hole to avoid air pockets. Insert the anchor or rebar to the required embedment depth and allow the resin to cure according to ambient temperature and product guidance before applying load.

Recommendations

Use compatible static mixers and dispensing equipment to ensure correct mixing ratio and homogeneous flow. Observe site temperature limits for chemical anchoring and follow curing times specified by the manufacturer for safe load application. Store cartridges in the supplied passive cool box and protect from freezing and prolonged direct heat.