Fresa de grabar Dremel 194DM 2 uds.

The Dremel® Max Carving Bit 194DM (2 pcs) is a heavy-duty, titanium nitride‑coated engraving and carving accessory with a 3.2 mm shank and 39 mm length. Designed for use with Dremel rotary tools, this pair of bits provides increased durability and consistent cutting performance for precision shaping, carving and engraving across a variety of materials including aerated concrete, brick, chipboard, hardwood, laminate, leather, plasterboard, plastic and plywood.

Advantages

The titanium nitride coating extends tool life to about twice that of standard, non‑coated accessories and improves wear resistance during extended use. The 3.2 mm high‑speed cutter geometry and cylinder profile enable deep material removal, flat bottom slots, flat side cuts and clean edge shaping while maintaining compatibility with common Dremel multi‑tools.

Suitable for

• Detailed engraving and carving on wood, plywood and hardwood
• Shaping and hollowing in soft masonry such as aerated concrete and brick
• Precision cutting, grooving and slotting in laminate, chipboard and plastic
• Leather work, inlaying and creating tapered holes or V‑cuts

Key specifications

• Brand: Dremel
• Model / MPN: 26150194DM
• Product: Engraver / Carving Bit, 2 pieces
• Shank diameter: 3.2 mm
• Total length: 39 mm
• Coating: Titanium Nitride (TiN)
• Compatibility: Dremel rotary tools / multi‑tools
• EAN: 8710364082780

How to use

Install the 3.2 mm shank securely in the collet of your Dremel tool. Allow the rotary tool and the accessory to perform the cutting without forcing or applying excessive pressure. For effective material removal and smoother results, use the accessory sides at an angle less than 90 degrees to the workpiece. To achieve V‑cuts, hold the bit at approximately 45 degrees. If the bit chatters instead of cutting, increase the RPM for a steadier operation. Test on scrap material first to confirm speed and technique before working on the final piece.

Recommendations

Wear appropriate eye and respiratory protection when engraving or carving; secure small workpieces and work at recommended speeds for each material. Inspect the accessory regularly and replace when worn to maintain cutting quality.