HP - DDR4 - Módulo - 8GB - DIMM 288-PIN - 2933 MHz / PC4-23400 registrado - ECC - para Workstation Z4 G4, Z6 G4, Z8 G4, ZCentral 4R (5YZ56AA)

The HP 5YZ56AA is an 8 GB DDR4 memory module operating at 2933 MHz with ECC support, designed to upgrade HP workstations and compatible systems. This single-module (1 x 8 GB) configuration provides low-power, high-speed memory that has been tested and validated for use with HP Workstations to improve system performance and memory reliability.

Advantages

This DDR4 8 GB module delivers a balance of speed and error-correcting reliability, reducing the risk of data corruption during intensive workloads. Its 2933 MHz clock speed improves multitasking responsiveness while ECC support enhances system stability. The module is designed for low power consumption and compatibility with HP Workstations, simplifying upgrades and maintenance.

Suitable for

Key specifications

How to use

Power down the workstation and disconnect all cables before installing the memory module. Open the system chassis according to the manufacturer's instructions, locate the appropriate DDR4 DIMM slot, and align the module with the slot notch. Press firmly and evenly until the module clicks into place. Close the chassis, reconnect cables, and power on the system. Verify that the system recognizes the new 8 GB module and that ECC is enabled in the system/BIOS settings if required.

Recommendations

For optimal compatibility and reliability, install this HP-tested memory module in HP Workstations or systems that explicitly support DDR4 2933 MHz ECC modules. When mixing modules, match capacity, speed, and ECC support where possible, and consult the system manual for supported memory configurations.