Módulo SFP Fibre Channel 8Gb Short Wave HP Enterprise B Series

The SFP Fibre Channel 8Gb Short Wave module HP Enterprise B Series is a small form-factor pluggable transceiver designed for storage area networks and enterprise storage connectivity. It supports 8 Gigabit Fibre Channel data rates over short-wave optics to deliver high-throughput, low-latency links between switches, storage arrays and HBAs. The module is intended for use in compatible HP Enterprise networking and storage equipment and follows the common SFP form factor for hot-pluggable installation.

Advantages

This SFP module provides 8 Gb/s Fibre Channel performance in a compact, hot-swappable package enabling dense port deployments. Short-wave optics are optimized for short and medium distance links inside data centers, reducing latency and maintaining signal integrity for storage traffic. The standardized SFP form factor simplifies replacements and interoperability in certified equipment while minimizing power consumption and rack space compared with larger optical transceivers.

Suitable for

• Connecting Fibre Channel switches within a data center SAN
• Linking storage arrays to host bus adapters (HBAs)
• Short- to medium-distance fibre runs in enterprise storage environments
• High-density port environments that require hot-pluggable transceivers

Key specifications

• Interface: Small Form-factor Pluggable (SFP)
• Protocol: Fibre Channel
• Maximum data rate: 8 Gbit/s
• Optical type: short-wave multimode/optimized short-reach optics
• Typical reach: short to medium distances within data center fiber plant
• Form factor: hot-pluggable
• Power consumption: low-power design suitable for high-density deployments

How to use

Install the SFP Fibre Channel 8Gb Short Wave module into an appropriate SFP port on a compatible switch, storage array or HBA while the host device is powered according to the equipment manufacturer's hot-plug guidelines. Ensure fiber patch cables and connectors match the optical type and polarity. After insertion, verify link status through the switch or storage management interface and configure Fibre Channel zoning or fabric parameters as required for your SAN topology.

Recommendations

Use multimode fibre patch cords rated for short-reach optics and maintain clean optical connectors to ensure reliable links. Match transceiver optics and cable type to the existing data center fiber plant. Confirm compatibility with your specific switch or storage model and follow equipment vendor guidance for firmware and supported transceiver lists.