Hub USB y PWM Lian Li EDGE HUB EG-HUB01W — 4× USB, 6× PWM, Blanco

The Lian Li EDGE HUB EG-HUB01W is a compact accessory that expands front-panel and internal connectivity by providing four USB ports and six PWM fan headers in a white chassis-friendly finish. Designed for desktop and workstation builds, this hub centralizes USB connections and PWM fan control to reduce cable clutter and enable coordinated fan speed management from a single point inside the case.

Advantages

This hub combines multiple functions in a small footprint, offering centralized USB expansion and PWM fan distribution without occupying full-size drive bays. The white finish integrates with light-colored builds while the internal layout helps tidy cable routing. By consolidating fan headers and USB ports, the unit simplifies hardware additions and maintenance, and allows for easier access to multiple USB devices and unified fan control.

Suitable for

• Custom desktop and workstation PC builds needing extra internal USB ports
• Systems that require additional PWM fan headers for multi-fan cooling setups
• Compact or windowed cases where cable management and clean aesthetics are important
• Upgrades where centralized fan control and USB expansion simplify routing and maintenance

Key specifications

• 4 × USB ports (internal hub expansion)
• 6 × PWM fan headers for 4- or 3-pin PWM fans
• White exterior finish suitable for light-colored builds
• Compact form factor designed for internal case mounting
• Centralized connection point for fan control and USB devices

How to use

Mount the hub in an appropriate internal location inside the PC case where cable lengths reach both fans and motherboard headers. Connect the hub's main power and control cable(s) to the motherboard or power supply as required by the system, then attach USB device cables to the hub's USB ports and plug each fan into the PWM headers. After connections are made, power on the system and configure fan profiles or USB settings in the motherboard firmware or compatible software to achieve the desired behavior.

Recommendations

Place the hub near the motherboard to minimize cable length to the control header, and route fan cables to avoid obstructing airflow. Verify motherboard fan header PWM compatibility before connecting multiple high-current fans to ensure stable control and prevent overloading a single header or cable run.