Panel solar Denver PPS-42000 10 W silicio monocristalino USB

The DENVER PPS-42000 is a portable, foldable 10 W solar panel with monocrystalline silicon cells and a USB-A output. Designed for ground placement, it delivers up to 5 V output and is intended to charge or power small electronic devices outdoors. Its compact dimensions (339 mm × 20 mm × 168 mm) make it easy to carry and position for sun exposure.

Advantages

The monocrystalline silicon construction provides efficient energy conversion for a module of this size, while the integrated USB-A connector enables straightforward plug-and-play charging of compatible devices. The foldable, lightweight design and small footprint simplify transport and setup for short trips, camping, or other outdoor activities where low-power charging is needed.

Suitable for

• Charging smartphones and small USB devices
• Powering portable battery packs and USB accessories
• Outdoor activities such as camping, hiking, or picnics
• Emergency or backup low-power charging situations

Key specifications

• Model: DENVER PPS-42000 (MPN 117250100000)
• Power: 10 W
• Cell type: Monocrystalline silicon
• Output connector: USB-A
• Maximum output voltage: 5 V
• Installation: Ground placement (portable)
• Dimensions (W × D × H): 339 mm × 20 mm × 168 mm
• Brand: DENVER

How to use

Place the foldable panel on a flat surface with direct sunlight exposure, orienting it toward the sun for maximum output. Unfold the panel fully and connect your device or power bank to the USB-A port. Monitor device charging; disconnect when the device is fully charged or when sunlight diminishes. Store the panel folded and protected when not in use.

Recommendations

For best performance, position the panel at an angle facing the sun and keep the surface clean and free of shade. Use the panel outdoors in dry conditions and avoid prolonged exposure to strong wind or heavy rain. Match the panel output to device charging requirements and use a compatible USB cable.