Inyector PoE ALLNET ALL-PI2014-I-BT90 90W Industrial Gigabit, carcasa metálica DIN

The ALLNET ALL-PI2014-I-BT90 90W Industrial Gigabit PoE injector is designed to deliver up to 90 watts of power over Ethernet while maintaining Gigabit network speeds. Encased in a robust metal housing compatible with DIN-rail mounting, this injector is intended for industrial and harsh-environment installations where stable PoE delivery and physical durability are required. It provides a single point to combine data and high-power PoE to feed compatible network devices without requiring PoE-capable switches.

Advantages

The metal DIN-compatible enclosure ensures mechanical protection and reliable heat dissipation for continuous operation in demanding environments. The injector supports full Gigabit Ethernet throughput while supplying up to 90 W to connected devices, enabling use with high-power PoE devices such as PTZ cameras and multi-radio wireless access points. Its industrial design focuses on dependability, simplified installation on DIN rails, and compatibility with standard Ethernet cabling.

Suitable for

• Powering outdoor and indoor surveillance cameras, including PTZ and multi-sensor units
• Feeding high-power wireless access points and mesh nodes in enterprise or industrial sites
• Supplying PoE-enabled switches, VoIP gateways or edge devices in control cabinets
• Deployments requiring DIN-rail mounting within industrial automation racks

Key specifications

• Maximum PoE power output: up to 90 W to a single powered device
• Data rate: Gigabit Ethernet (10/100/1000 Mbps)
• Form factor: metal housing compatible with DIN-rail installation
• Connector types: standard RJ45 data/power output and RJ45 data input
• Operating environment: industrial-grade construction suitable for harsh conditions
• Power input: external AC/DC power source required to deliver full PoE output

How to use

Mount the injector on a DIN rail inside an appropriate enclosure or cabinet and connect the injector's data input port to a network switch using standard Ethernet cabling. Connect the powered device to the output RJ45 port to deliver both data and PoE power. Ensure the injector is supplied with the correct external power adapter or wiring capable of providing sufficient wattage for the connected device. Verify cable ratings and implement proper grounding and surge protection according to site requirements.

Recommendations

Place the injector in ventilated equipment cabinets and avoid covering the metal housing to maintain heat dissipation. Use Cat5e or higher-rated Ethernet cable for Gigabit performance and ensure the power source matches the required capacity to prevent undervoltage. For critical or outdoor deployments, combine the injector with appropriate surge protection and observe local electrical codes when wiring the power input.