Inyector PoE TELTONIKA PR325EUB – puerto Gigabit único, 30 W, EU

TELTONIKA PR325EUB is a single-port Gigabit Power over Ethernet (PoE) injector that supplies up to 30W of DC power over a standard Ethernet cable while providing a Gigabit data connection. Built for use with EU mains sockets, this compact injector enables installation of PoE devices where a PoE-capable switch is not available, simplifying deployments of cameras, wireless access points and IP phones by separating power sourcing from the network switch.

Advantages

The device supports full Gigabit data throughput alongside IEEE-compliant PoE power delivery up to 30W, allowing high-bandwidth devices and cameras to operate without performance loss. Its single-port design and compact housing make it easy to install in tight spaces or near the powered device, and the EU power plug ensures compatibility with regional outlets. The injector reduces the need for additional cabling or retrofit power solutions and is suitable for point-to-point deployments where centralized PoE switches are impractical.

Suitable for

• Powering PoE surveillance cameras in small to medium installations
• Supplying wireless access points in areas without PoE switches
• Providing power and data to VoIP phones and intercoms
• Upgrading single devices to PoE without replacing existing network switches

Key specifications

• Network port: 1 × Gigabit Ethernet data port with PoE output
• Maximum power output: up to 30 watts delivered over Ethernet
• Power input: designed for EU mains socket compatibility
• Operating mode: PoE injector that combines DC power with data on a single cable
• Form factor: compact inline injector for easy placement near the powered device

How to use

Connect the injector to an EU mains outlet, then link your network switch or router to the injector’s data input LAN port. Connect the powered device to the PoE output port using a Cat5e or better Ethernet cable to deliver both power and data. Ensure the powered device supports PoE and that its power requirements do not exceed the injector’s 30W output. Verify link/activity LEDs (if present) to confirm data connectivity and power delivery before finalizing the installation.

Recommendations

Place the injector close to either the powered device or the network switch depending on cable run lengths; use Cat5e or higher cables for reliable Gigabit performance and to minimize power loss. Do not exceed the 30W power budget per port. For outdoor or harsh-environment devices, install the injector in a protected indoor location or use weatherproof enclosures for exposed connections.