Juego de barras colectoras Rittal SV 3439.010, 3 uds.

Rittal SV 3439.010 is a set of three bus bars supplied as a pack of 3 pieces, designed for electrical distribution and panel assembly. These bus bars provide conductive connections inside switchgear, control cabinets and distribution enclosures and are suitable for connecting round conductors or laminated copper bars in bar systems with 60 mm centre-to-centre spacing. The product is intended for professional electrical and industrial installations where defined current paths and secure conductor joining are required.

Advantages

The three-piece set offers a ready-matched solution for triple-rail distribution, ensuring consistent spacing and alignment. Manufactured to meet industrial mounting requirements, the bus bars facilitate reliable conductivity and mechanical stability within enclosures. Their compatibility with round conductors and laminated copper bars supports flexible wiring practices while the fixed 60 mm centre-to-centre spacing simplifies design and installation in compatible panel systems.

Suitable for

Key specifications

How to use

Install the bus bars inside the enclosure or panel according to the cabinet manufacturer’s mounting layout and electrical schematic. Ensure the bar system has 60 mm centre-to-centre spacing before fitting. Secure each bus bar using the appropriate fastening points and hardware, make electrical connections to round conductors or laminated copper bars with suitable clamps or connectors, and tighten to the torque values specified by the connection hardware manufacturer. Verify insulation clearances and phase separation as required by applicable standards before energising the system.

Recommendations

Use only in compatible bar systems with 60 mm spacing; inspect physical condition before installation, follow applicable electrical codes, and use appropriate personal protective equipment when assembling or servicing live parts. For best performance, combine with matching fastening and connection accessories recommended for the enclosure manufacturer.